Spice up your Arduino project with a...
Key Features 2 x 5K Potentiometers for reading the X and Y position 1 x Normally Open Momentary Switch (Closes with downward pressure on the joystick) Simple 5 pin interface with clearly marked pins on standard 0.1" centers Connector: +5V, GND, VRx, VR, SW
With 1 touch key; Touch detection IC is designed for using variable-area key to replace the traditional button; Low power consumption and wide voltage range; Board size: 15.5 x 23.5mm; 1 lead: power+ VCC; 2 lead: output OUT; 3 lead: power- GND
Never hunt around for another crystal again, with the Si5351A clock generator breakout from Adafruit! This chip has a precision 25MHz crystal reference and internal PLL and dividers so it can generate just about any frequency, from <8KHz up to 150+ MHz.
This breakout board features the easy-to-use MCP4725 12-bit DAC. Control it via I2C and send it the value you want it to output, and the VOUT pin will have it. Great for audio / analog projects, such as when you can't use PWM but need a sine wave or adjustable bias point.